Electrical Power Tool Safety •

• Use the tool only for its designed purpose.
• Read the Owner’s Manual and follow manufacturer’s safety instructions.
• Remember electric-powered tools must have a three-wire plug with ground or be double
insulated.
• Use of electric-powered tools with a GFCI breakers will drastically reduce the possibility of
electric shock or electrocution.
• Don appropriate PPE.
• If an extension cord is required, make sure it is for the correct wattage and has the proper plugs.
Verify condition of the cord and plugs and check for rated use: indoor or outdoor.
• Ensure the power switch is “OFF” before plugging or unplugging tools.
• Never disconnect power by pulling on the cord – use the PLUG.
• Never carry a tool by the cord.
• Unplug the cord before making adjustments, changing/replacing parts/accessories.
• Inspect tool before each use. Replace tool if parts are worn or damaged .
Remove from service and tag “Danger, Do Not Operate.”
• Do not use electric-powered tools in damp or wet locations.
• Keep the cord away from heat, oil/chemicals, sharp edges and ensure it doesn’t become a
tripping hazard.
• Remember there are specific practices also when drilling or penetrating areas which may contain
energized conductors.
1. Drilling or penetrating areas which contain or may contain energized electrical conductors is
considered "working near". Such work requires extreme caution and good planning. Drills or
penetrating equipment must be grounded so that accidental contact with an unexpected
energized electrical conductor will be cleared quickly by the circuit protective device.
Double insulated equipment cannot be counted on to provide protection when accidental
contact is made with energized circuits. A drill bit stop should be used to limit the distance of
any penetration.
2. Enclosures, raceways, compartments, walls, ceilings, floors or underground areas where
energized electrical conductors are or may be hidden from direct view must be thoroughly
investigated before penetrating into them. The custodian should ensure that an engineering
review of drawings or other documentation about the work site is conducted.

Extension Cords
• Inspect the cord before each use. Replace the cord if worn or damaged. Remove from service
and tag “Danger, Do Not Operate.”
• Keep extension cords away from heat, oil/chemicals, sharp edges and ensure they do not become
a tripping hazard.
• Make sure extension cord is for the correct amperage and has the proper plug.
• Verify condition of the cord and plugs and check rated use: indoor or outdoor.
• Don’t overload electrical outlets.
• Never disconnect power by pulling on the cord – use the PLUG.